LIke us on
MIKE WALLER YACHT DESIGN
Coral Cove 31 Catamaran - Mike Waller Yacht Design
TC750 CATAMARAN
Designed by Mike Waller
BUY YOUR PLANS BELOW
Study Plans
(downloaded)
$25.00 Aud
Full Plans
(emailed)
$450.00 Aud
DIMENSIONS
L.O.A. 7.50 Mtrs
L.W.L. 7.13 Mtrs
Beam 3.45 Mtrs
Draft (boards up) 0.32 Mtrs
Draft (boards down) 1.45 Mtrs
Displacement 1650 Kg
Weight 1350 Kg
Sail Area 37.31 Squ Mtrs
Payload 700 Kg
Note# All displacement and payload weights above are as per designed plan, and cannot be guaranteed.
DIMENSIONS
L.O.A. 7.50 Mtrs
L.W.L. 7.13 Mtrs
Beam 3.45 Mtrs
Draft (boards up) 0.32 Mtrs
Draft (Boards down) 1.45 Mtrs
Displacement 1650 Kg
Weight 1350 Kg
Sail Area 37.31 Squ Mtrs
Payload 700 Kg
Note# All displacement and payload weights above are as per designed plan, and cannot be guaranteed.
Weight
The WALLER TC 750 was designed as an easy to build and sail, low cost multi-hull yacht, , designed for a family of 4. The TC 750 is ideal for a couple, or a family with young children. The cabin features a full size double berth, a good sized and easy to use galley, and a small dinette area around which 3-4 can sit in comfort. There is also a seperate toilet compartment with room for a small shower and fold down basin, as well as two large quarter berths aft . At anchor, a boom tent will turn the cockpit into a huge covered living area.

The multi chine hull (flat bottom with 2 chines) is constructed from sheet ply over plywood bulkheads, with minimal timber framing. Construction employs the timber / epoxy building technique, is very strong to stand up to the rigors of being stored on a trailer frame, and is simple and straight forward with the entire shell built as a single unit. When turned over, very little is required to complete the vessel.

This yacht features twin dagger boards and rudders.

The rig is a simple 7/8 design, with non rotating spars and utilizing off the shelf fittings. It can be home built if desired. The rig features an assymetrical spinnaker set from a bow pole, but a normal symetrical spinnaker could be used if desired.

Particular care has been taken to ensure that this boat is both a safe and reliable performer, with an emphasis on good cruising performance and accomodation rather than all out racing, in keeping with its intended use as a family boat. Note that its intended area of use is sheltered and semi sheltered waters, and not open water.

Note that this vessel is wider than the standard road trailing width for most areas. Normally this yacht would live on a trailer frame at the local yacht club (much cheaper than a berth or mooring)
.
Logo - MIke Waller Yacht Design
MIKE WALLER YACHT DESIGN
PHOTO ALBUM INFO
Please read this before ordering plans >